Search results for: 'general swim4 spa st 268804'

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

Measure the chemical balance of chlorine based water with AquaChek Chlorine 4-in-1 Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Free Chlorine, pH, Total Alkalinity, Stabilizer (Cyanuric Acid)

MS8000 Relay for FST. This unit reverses polarity of the power in your spa’s entertainment system to raise and lower the television.

Replacement screw kit for CoverMate III DeckMount brackets

Contractor Series Filter PWW35L 2012, except CS 415.

The bracket is used for CoverMate easy to install the pole directly to your hot tub.

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness

This is the OEM factory replacement screw kit for your CoverMate CoverShelf.

Replacement screw kit for CoverMate II. This kit includes all of your replacement screws for your CoverMate II cover lifter.

SpaBoss Descummer boosts the effectiveness of the filtration system in your spa or hot tub, helping to keep the water clean and free of left-over contaminants.

The pivot arm for the CoverMate III is a direct OEM factory replacement for the original bar.

Replacement support arm for the CoverMate I Eco B and the inner support arm for the CoverMate Freestyle.