Search results for: 'heater motor from master spa hl7laing e 14 pump'

1.5 x 1/2 inch Threaded Reducer Bushing

Drain Faucet Valve with 3/4 inch Barb

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

Replacement screw kit for CoverMate III DeckMount brackets

1/2 x 3/8 inch 7 Barb Manifold

ML900 Topside Control Panel

(Replacement for the MAS560 Control Panel X310840)

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

Adjustable Clarity pillow

This is the H2X Shaft Pin with SKU number X400130 and is one element that goes with the Blade Prop Kit. The H2X Shaft pin is a prop shaft pin and is a component of the wave propulsion.

The Locking Shock for CoverMate 3 a replacement part for the CoverMate 3 hydraulic-assisted cover lift. It is important to remember to unlock the shock before pulling the CoverMate down on to your home spa so that you do not cause damage to the unit. This hydraulic-assisted cover lift is a lower-cost option that still delivers a quality lifting performance of the cover.

Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.

3/8" air bleed assembly black