Search results for: 'spa side cover13 screws'

MS 50 U Control Pack

This pivot arm assembly is made for your CoverMate Freestyle cover lifter.

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

MS8000 Relay for FST. This unit reverses polarity of the power in your spa’s entertainment system to raise and lower the television.

Contractor Series Filter PWW35L 2012, except CS 415.

Measure the chemical balance of your chlorine based water with AquaChek TruTest Chlorine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

Measure the chemical balance of your bromine based water with AquaChek TruTest Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity

SpaBoss Descummer boosts the effectiveness of the filtration system in your spa or hot tub, helping to keep the water clean and free of left-over contaminants.

The pivot arm for the CoverMate III is a direct OEM factory replacement for the original bar.

The powder coated aluminum coupler for the CoverMate I, CoverMate II and CoverMate III is a direct replacement for the original bar.

This is the Locking Shock for the Cover Valet.

This locking shocks for your Cover Valet are the OEM, replacement part for the original shocks on the cover valet equipment.

Support arm for CoverMate I and upper support arm for the CoverMate II and CoverMate Easy.