Search results for: '10 round spa coverm 4 tubs custom custom'

The 70" x 83" Hot Tub Cover (Short-edge Fold) (SKU: 457187) is designed to fit your Master Spas® hot tub. This cover ensures extreme energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular cover folds along the shortest 70-inch edge. For a hot tub cover folding on the long edge, please see 83" x 70" Hot Tub Cover (Long-edge Fold).

The Bracket Kit for Master Spas CoverMate I with Master Bracket is one of the sections that makes up the CoverMate I model of a hydraulic cover lifter. This Extended Pivot Arm has SKU# 100571 and is a replacement part for the CoverMate I, which is sold here by Master Spa Parts. The Master bracket attaches to the wood in the upper-right corner to provide additional support.

These hydraulic shocks for your CoverMate Freestyle are the replacement part for the original shocks on your cover.

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

The Grey, Legend Small Waterfall Pillow (4 Pins) is made to go with the Master Spa Legend Series Hot Tubs.

The 1/4-20 Threaded Insert for Wood from Master Spa Parts are threaded nuts that can be hammered or screwed into material. Used in a pre-drilled hole to provide an extra secure hold between your spa skirting parts.

This kit is a factory direct, replacement screw kit that contains a bag of screws used for installation with the CoverMate III Eco B.

This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.

This Understyle Screw Kit for CoverMate II by Leisure Concepts is an OEM factory replacement screw kit.

This is a OEM factory direct replacement rubber stopper smash cap for the CoverMate I hot tub cover. Easily replace your old smash cap with this replacement!

Replacement screw kit for the CoverMate I Master Bracket. This kit includes all of your replacement screws for your cover lifter bracket.

Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.

Note: This hot tub cover folds along the long edge.