Search results for: 'foam cup cross specific sx trim holder round'

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

The bracket is used for CoverMate easy to install the pole directly to your hot tub.

The 70" x 83" Hot Tub Cover (Short-edge Fold) (SKU: 457187) is designed to fit your Master Spas® hot tub. This cover ensures extreme energy efficiency as it is made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This particular cover folds along the shortest 70-inch edge. For a hot tub cover folding on the long edge, please see 83" x 70" Hot Tub Cover (Long-edge Fold).

The 7x7 Master Spas® hot tub replacement cover (84” x 84”) is a Master Spa Factory OEM replacment (SKU: X454777).

This cover fits other makes of Master Spa, and is the standard at 84" x 84" with a 6" radius.

This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Foam Kickboard

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

The sensor assembly is specifically designed to go with Down East Spas and Legend Series Master Spas (select 1996-1999 models). It is a replacement for Balboa Dual Sensor Assembly with Temperature and Hi-Limit Sensor. Compatible with all Balboa systems that use this type of sensor.

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

The 66" x 78" Master Spas® factory direct OEM replacement hot tub cover (SKU: 66x78) is designed to fit your Master Spas hot tub. It comes standard with a 1.5lb foam density, long steam stopper cushions to help prevent any sort of heat loss. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.

Note: This particular cover folds along the short edge. If you need a cover with these same dimensions (66" x 78") but that folds along the long edge, try our 66 × 78 Inch Hot Tub Cover (Long-edge fold).

The 1.5 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.

The 2 inch Pump O-Ring fits neatly into pump joints/parts that need to create a tight seal. Works with 2 inch nuts.

Get all the parts you need to fully assembly your replacement spa pump.