Search results for: 'vacuum for master six'
- Did you mean
- vacuum for master sx
- vacuum for master spx
- Related search terms
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spa - X232607 - 1" Lighted Halo Air Control
- Master Spas - Topside Panel, MP900, No Overlay, For MS40 - X310203, 50305
- Master Spa - X245375 - 2 inch DSG 6-Spoke Diverter
- Master Spas, Down East, Emerald Spas Suction Drain Cover, 4-7/8 inch 0.D. VGB Law Compliant Replaced 0bsolete Original
The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.
-
The Master Spa® Factory OEM 84” x 84” replacement hot tub cover has a 12" radius and is for Getaway Spas ONLY.
This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.
-
The custom factory OEM replacement 120” x 94” Master Spas® swim spa tub cover (SKU: X454108) is specifically designed to fit your Master Spas® hot tub. This swim spa cover has a six-inch thick foam insulation, which tapers down to four inches along the sides. This 24 R-value (the higher the R-value, the better the heat retention) energy-efficient cover comes with a 1.5lb foam density and long stopper steam cushions that help prevent heat loss, and upgraded rubber grip handles.
Note: This four-segment swim spa cover folds along the longest dimension (the 120" side).
-
The heater gasket o-ring is a replacement part for the o-rings that come with your spa and support the heater gasket so that there is a tight fit. If you don’t see your model listed, it may still work – so please give our customer service a call!
-
The bracket is used for CoverMate easy to install the pole directly to your hot tub.
-
Mini-Storm Multi-Massage with M.S. Logo
-
Poly-Storm Multi-Massage with M.S. Logo
-
SST Power Storm Directional with M.S. Logo
-
The 7' x 6.5' (84" x 78") Master Spas® replacement hot tub cover (SKU: X454765) is a Master Spa Factory OEM replacement. It is specifically designed to fit your Master Spas® hot tub. This cover is extremely energy efficient, as it's made of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and unfazed by UV rays.
Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.
