Search results for: 'guide spa jet'

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

The Master Spa® Factory OEM 84" x 66" replacement hot tub cover is designed to fit your Master Spas® hot tub. This replacement custom hot tub cover is extremely energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

SpaBoss pH Plus easily raises pH levels in spas and hot tubs that are too low below the recommended safe range of 7.2 to 7.6. If levels are too low, your hot tub water can become acidic and other nasty side effects can happen.

6PT Spyder LED harness with boots

Check Valve

Waterfall Diverter 3//4"

2 x 1.5 inch Reducer Bushing

3/4" Eclipse DSG/Titanium Waterfall diverter

Topside control panel extension cord 25'

1.5 x 1/2 inch Threaded Reducer Bushing

Drain Faucet Valve with 3/4 inch Barb

This Master Spa Factory OEM 79" x 69" hot tub cover replacement (SKU: 457969) is specifically designed to fit your Master Spas® hot tub. This cover ensures energy efficiency as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full-length heat seal to help prevent heat loss. Additionally, it is made of a high end marine-grade vinyl covering that is mildew treated, and consists of upgraded rubber grip handles.

Note: This 79" x 69" hot tub cover folds along the long edge.