Search results for: 'covermate 1 fit mount master sp1 swim4 sp2'

This kit includes left and right brackets and screws for your CoverMate I Eco B. They are all factory direct, OEM replacement parts.

The Grey Legend Neck Jet Pillow fits Legend Series Master Spas line of hot tubs from 2005 - 2009.

38" Extended Pivot Arm for CoverMate III

Replacement screw kit for CoverMate II. This kit includes all of your replacement screws for your CoverMate II cover lifter.

This is the replacement part for the hardened foam end cap rubber sleeve piece for the CoverMate I.

This right support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover.

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the right arm is on the right side.*

This is the Right Support Arm for the CoverMate III Eco B cover lifter.

*To determine if this is the correct replacement support arm need, look at your cover in the open position. While facing the spa and open cover lifter, the right support arm is on the right side.*

The Sensor, 24” x ¼” F/560 M7 is a high limit temp replacement sensor for the MAS560 sensor found in most Down East and Legend Series Master Spas.

Don’t let a broken sensor prevent you from your enjoying your spa when you want to.

DSG Ozone Wall Fitting

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**

The coupler is used to connect the lower and side portions of your CoverMate Easy product.

The CoverCatch helps keep your spa cover close by and off the ground! It is ideal for smaller sizes spas and covers.