Search results for: 'hot tub cover 2 coverm made inch 1'

This screw kit is a bag of screws used for installation with the CoverMate I Eco B. They are factory direct, OEM replacement parts!

The CoverMate I with Master Bracket is designed for 2014 and older Master Spas swim spas. The “Master Bracket” is designed to screw into the wood frame of the swim spa behind the corner. This gives your cover lifter a way more secure attachment to your swim spa!

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

Over time, your spa or hot tub’s air controls may wear out, leaving you with less jetting action and much less enjoyment and relaxation. With the 1 Inch Molded Air Control (Grey), Master Spa Parts customers can affordably replace their air controls. This part is compatible with many models of Down East Spas, Freedom Spas, and the Master Spas® Legend Series.

This is the replacement Bushing for CoverMate I, CoverMate II and CoverMate III cover lifters. The Bushing is just $3.05 each and is sold here by Master Spa Parts. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lifts that can only be found in the CoverMate series. This part has SKU# 100344 and ships free when it is part of a total order $99 or more from Master Spa Parts.

This is the replacement Bracket Kit for CoverMate II and it can be screw-mounted low on the spa. The Bracket Kit for the CoverMate II is for a model that needs only 18 inches of clearance behind the spa in order to operate. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate II Cover Lift. This part is sold for $73.45 here at Master Spa Parts.

The 8' x 8' (94" x 94") Master Spas® hot tub replacement cover is a Master Spa Factory OEM replacement (SKU: X454888). It is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient, as it's made of a thick 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal. It has been upgraded to include two rubber grip handles and is made of a high quality marine-grade vinyl covering that is mildew treated and protects against UV rays.

The replacement, factory direct left outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left outer handle is on the left side.*

This is the replacement aluminum left bracket for your CoverMate cover lifter.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the left bracket is on the left side.*

This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240)  is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.

1/2" Sx3/4" Barb Adapter

The pivot arm for the CoverMate III is a direct OEM factory replacement for the original bar.