Search results for: 'sp1 wired cap wave in tub faucet cartridge'

*Due to a nationwide shortage of chlorine, prices have increased.*

(BioLab, one of the countries major suppliers of chlorine tablets, was destroyed by Hurricane Laura - contributing to the already lacking nationwide chlorine supply.)

---

SpaBoss Chlor-Aid - 5lb. container is a great way to disinfect your hot tub water and keep it algae free! This chlorine product is a great way to disinfect your spa water while keeping your alkalinity balance and pH in line!

Swim Spa Propulsion Control Panel (V/N 50209)

5/8 inch Prop Shaft Bushing

7/8 inch Propulsion Motor Bushing

2 inch, 5 Scallop Graphite Diverter Valve

Thumbscrew 1/4 - 20 x 1.75 inch. These are used to secure your corner skirting pieces on your spa in place. This part is the longer of the two thumb-screws available.

3-Way Jumper for MS5000. Wire jumper for components to plug into one spot on the pc board. Usually used with the circulation pump and ozone.

Replacement plastic screw kit. This is the replacement screw kit for the CoverMate III

The Lounge/Small Corner Pillow will replace the hot tub pillow that came in your Master Spa hot tub when you first bought it.

The Master Spa® Factory OEM 84" x 70" replacement hot tub cover is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full-length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

Note: This particular hot tub cover folds along the long edge. Find the corresponding short-edge fold cover here.

The Black Flat Pillow from Master Spa will match your original hot tub pillow.

The Grey Terminal Block for H2X is designed specifically to work with your H2X Swim Spa. Feed through up to 750V through this Terminal Block.