Search results for: 'axis coverm spa additional support'

SpaBoss No Phos is phosphate control for your spa – a naturally formulated additive that helps to remove phosphates from your spa water – keeping it clean and clear! (16 oz. bottle)

The replacement, factory direct left outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left outer handle is on the left side.*

This replacement OEM factory direct coupler insert is a long part used to lengthen your raise and lower bar for your hot tub cover.

The Grey, Legend Small Waterfall Pillow (4 Pins) is made to go with the Master Spa Legend Series Hot Tubs.

The Grey Legend Neck Jet Pillow fits Legend Series Master Spas line of hot tubs from 2005 - 2009.

The Black Wrap Around Master Spas Pillow will nicely replace your original hot tub pillow for certain Down East Master Spa hot tubs (2003-2009).

This is a factory replacement plastic bracket for your CoverMate CoverShelf.

The Spa Dragon is a patented monitoring system with thermal backup protection that prevents freeze damage caused by equipment failure. Stay worry-free in winter, with real-time alerts and automatic heating activation—no matter where you are.

Boomerang brackets (1 pair) are specifically designed for use with the Visionlift Boomerang Cover Lifter by Ultralift. These brackets attach to your existing Ultralift sliding bracket, allowing your hot tub cover to fully open to the ground without the need for additional drilling. 

The Ultralift Undermount conversion kit allows for you to change your standard cover lift into one with an undermount. With this undermount, there is no more drilling into the side of your spa to install a cover lifter. This is bought in addition to a Ultralift cover lifter.

The heater gasket o-ring is a replacement part for the o-rings that come with your spa and support the heater gasket so that there is a tight fit. If you don’t see your model listed, it may still work – so please give our customer service a call!

The 8' x 17' cover (94" x 201") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement part. All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4".  This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors.