Search results for: 'coverm foam master spa'
- Did you mean
- coverm forc master spa
- cover13 foam master sp2
- Related search terms
- spa cover 93" x 118"
- Master Spa - CLSEPRSET3 - Clarity & Healthy Living EPR Filter Set - (2) X268548 - PMA-R3 and PMA-EPR - (1) X268532
- Master Spa - X232607 - 1" Lighted Halo Air Control
- Master Spas - Topside Panel, MP900, No Overlay, For MS40 - X310203, 50305
- Master Spas, Down East, Emerald Spas Suction Drain Cover, 4-7/8 inch 0.D. VGB Law Compliant Replaced 0bsolete Original
This Master Spa Factory OEM 78” x 78” hot tub cover replacement (SKU: X120240) is specifically designed to fit your Master Spas® hot tub. This cover is energy efficient as it consists of a 1.5-pound foam density, six-inch thick foam insulation (which tapers to 4-inches along the sides), and a full length heat seal to help prevent heat loss. It is also made of a high end marine-grade vinyl covering that is mildrew treated, and consists of upgraded rubber grip handles.
-
This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**
-
The Black Neck Jet Pillow is a generic pillow designed to work with most Master Spa Hot Tubs including Down East Spas and Freedom Spas (2003-2009).
-
The right cover piece snaps into the fitted location on the right side and covers all the pieces on that side.
*To determine if this is the correct replacement cover piece you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the right cover piece is on the right side.*
-
The Grey Legend Neck Jet Pillow fits Legend Series Master Spas line of hot tubs from 2005 - 2009.
-
This is the replacement right Large Bracket Cover for the CoverMate III cover lifter.
*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right large bracket cover is on the right side.*
-
Our Master Spas® 83" x 70" hot tub cover (SKU: 458771) is a factory direct OEM replacement cover specifically designed to fit your Master Spas® hot tub. Consisting of 1.5lb foam density, long steam stopper cushions, six-inch foam insulation, four inch tapered sides, upgraded rubber grip handles and a 24-R value (the greater the R-value, the better the heat storage and heat retention), this cover prevents heat loss and is extremely energy efficient.
Note: This hot tub cover folds along the long edge.
-
This heater is a replacement part for the original heater in your Master Spas swim spa and hot tub models. Easily installable so you can get back to enjoying your heated Swim spa and hot tub in no time at all.
This is an original heater assembly made by Balboa Group - leaders in manufacturing spa parts.
Features:
-
The 5 Amp Slow Blow (FST) by Master Spas is a replacement fuse made to go in your home spa. The fuse allows a greater level of power to flow without disrupting the circuit or blowing the fuse itself. The piece is affordable, easy to install and can be a simple fix for a problem with your spa
-
The right outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.
*To determine if this is the correct replacement handle you need, look at your cover in the open position. While facing the open cover, the right handle is on right side.*
