Search results for: 'tini spx heater assembly'

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

The pressure switch in your spa controls the water pressure in your spa. The pressure switch harness is a replacement part for the original pressure switch harness that allows the pressure switch to be connected to the controls of your spa.

Designed specifically for 2015 Michael Phelps Swim Spas this sensor is a replacement for the sensor in your spa’s heating system allowing you to control the heat of your spa from the external control panel. If you don’t see your model listed, it may still work – so please give our customer service a call!

MS 50 U Control Pack

The Sensor, 24” x ¼” F/560 M7 is a high limit temp replacement sensor for the MAS560 sensor found in most Down East and Legend Series Master Spas.

Don’t let a broken sensor prevent you from your enjoying your spa when you want to.

Washer for the regular sized Snap Caps. These are the beauty caps that cover the screws that hold your side panels on providing your spa with a professional beautiful finish.

The 12-inch A&B M7 Temp/High Sensor is a replacement sensor for several Spa models including the Clarity, Down East, Contractor, Freedom, Getaway, H2X Swim Spas, Healthy Living Hot Spas, Legacy Whirlpool, Legend Series Master Spas, Michael Phelps Swim Spas and Twilight Series Spas. If you don’t see your model listed, it may still work – so please give our customer service a call!

1/4 inch Washer for Oversized Snap Cap. These are the beauty caps that cover the screws that hold your side panels on. Available in 2 different sizes and 3 different colors.

The 3/8 x 1/4 inch Threaded Barb. This threads into the pump for the constant water feed to your spa pump. Only used on some model pumps.

Call us to verify that this is the right part for your pump.

The O-Ring for Power WOW Drain Plug is the O-ring that goes with the drain plug for the Pentair Power WOW pump (SKU : X275230).This creates a tight seal for wet end drain.

The Master Diverter Valve Handle is a genuine oem replacement part for your Master Spas hot tub. Diverter valves are made to redirect the water from your spa into different directions, as well as fully (or partially) shutting off your hot tub water flow. This specific diverter valve has a 2”inch handle and has an all over width of 4.5” inches.

The Drain Plug for Power WOW is a wet end drain plug for the Pentair Power WOW. This part does not come with an O-ring. The part allows the pump to be drained of stagnant water so protect it from damage and to keep it running for as long as possible.