Search results for: '100504 Right CMIII Bracket'

This is the five-inch nut that is a replacement part sold right here, through Master Spa Parts. This replacement piece measures five inches in diameter and works on several models within the 2005 Down East Spa series of home spas. Made of sturdy plastic this replacement part has a SKU number of X241054 and is designed to provide a tight fit in order to prevent leaks.

The Master Spa Parts team is here to offer you a vast selection of replacement filter PLBS50 , including the Contractor Series Filter 2011 and Earlier product. This Pleatco Plus filter includes action built right into the pleats, ensuring effective protection even after repeat rinses. Order a filter for Contractor Series Spas (Master Spas®), today!

This is the Extended Pivot Arm for CoverMate III and it is a replacement part for your CoverMate III Cover Lift. There is a reliability, ease of operation and ultimate beauty to the hydraulic cover lift that can only be found in the CoverMate III Cover Lift. This part is 43 inches long and is sold here at Master Spa Parts.

1/4 inch Washer for Oversized Snap Cap. These are the beauty caps that cover the screws that hold your side panels on. Available in 2 different sizes and 3 different colors.

The 11 amp, 2 speed 120 volt Pump is an insulated wet end pump designed as a replacement pump.

The Pump, 2HP 2 Speed 48 Frame is a powerful replacement pump for the select Contractor, Down East, H2X, Legacy, Legend Series Master Spas and Twilight Series models. A broken pump should not ruin your fun. Order a replacement for your spa/hot tub today and get back to enjoying.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

The 1/4-20 Threaded Insert for Wood from Master Spa Parts are threaded nuts that can be hammered or screwed into material. Used in a pre-drilled hole to provide an extra secure hold between your spa skirting parts.

Keep your entertainment system protected from the elements and theft with this universal lock and key set. Can work as a replacement for your original lock on your spa’s entertainment system.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

The Master Spa Parts 8' x 18' cover (94" x 215") Master Spas® swim spa replacement cover is a Master Spa Factory OEM replacement part. All swim spa covers are made specifically to fit your Master Spas swim spa and come 6" thick in the middle and taper off to 4".  This cover includes an energy efficient 1.5 lb foam density and a 24 R-value, with a full length heat seal and upgraded rubber grip handles (included!). They are also available in 18 different colors to match the aesthetic of your hot tub area.