Search results for: 'cup your chemicals be used in a la sp1'

The replacement, factory direct left outer handle is a powder-coated aluminum part that is used to easily open and close your CoverMate Freestyle.

*To determine if this is the correct replacement handle you need, look at your hot tub cover in the open position. While facing the spa and open cover lifter, the left outer handle is on the left side.*

Measure the chemical balance of bromine based water with AquaChek Red 4-in-1 Bromine Test Strips in 15 seconds.

• Count: 50 test strips
• Tests for: Total Bromine, pH, Total Alkalinity and Total Hardness

Visionlift Pads provide a place for your Visionlift Boomerang cover lifter to rest – that’s not on the ground! They keep your cover lifter from getting scratched or torn up on the ground/deck.

Get rid of excess foam in your hot tub quickly and prevent foam from ruining your enjoyment and relaxation! SpaBoss Defoamer is safe to use even if you’re in the hot tub at the same time.

The Original Swim Tether is designed to provide a unique resistance workout for swimmers of all skill levels. Quickly install and assemble to swim in most swim spas and swimming pools. A minimum of fourteen feet of swim space is recommended. Using optimal lift and an elevated connection point allows the swimmer to swim unencumbered by cords and restrictive ankle attachments.

Don't let a failed circuit board shut down the fun and relaxation in your spa or hot tub. Through the Master Spa Parts online store, you’ll discover great savings and high-quality OEM replacement circuit boards, such as this MS1500 PC Board (V/N 54494). Plus, you will get it fast and with free shipping (most U.S. addresses) when you replace your spa’s circuit board (MS1500) through us!

This kit is a factory direct, replacement screw kit that contains a bag of screws used for installation with the CoverMate III Eco B.

3/8" x 1.5" Fender Washer used on the propulsion system in the swim spas. The 3/8" x 1.5" Fender Washer from Master Spa Parts has a thinner body compared to the flat washer and provides an even wider surface area of support for fasteners.

If all of the sudden, you find your spa's jet pumps, filters, jets, or water temperature stability begin to fail all at once, there's a good chance it may be due to the circuit board.

When you check out our online store, you'll find the Master Spas® 501X daughter pc board from Master Spas® and many other economical spa circuit boards. You can expect fast and free shipping options when you purchase this Momentum 80 circuit board replacement from the Master Spa Parts online store. 

The 2 inch Pump Split Nut is used as a replacement for the pump union that would need to be re-plumbed. You can cut off the old pump union and replace with this split nut. This comes with the 2 screws that screw and hold it together.

The CoverMate II Understyle Cover Lifter is there for you when you need it and tucked away in the background while your hot tub is in use! It has two plates that slide easily underneath your hot tub. The cover lifter only requires 18 inches of clearance behind your spa.

This is a copper jumper strap normally used with the ground wires in the spa. These are mounted on the back of the pumps connecting the ground wire. Is part of the connections from the heater to the PC Board.