Search results for: 'hot tub cover 2 coverm mount inch 1'

The Coupler insert (2 per unit) is a long part used to lengthen your raise and lower bar for your hot tub cover.

1/2" Sx3/4" Barb Adapter

This kit is a factory direct, replacement screw kit that contains a bag of screws used for installation with the CoverMate III Eco B.

This is the replacement right Large Bracket Cover for the CoverMate III cover lifter.

*To determine if this is the correct replacement bracket need, look at your cover in the open position. While facing the spa and open cover lifter, the right large bracket cover is on the right side.*

Has the ball in your air control become stuck, or has it started to “whistle?” It is most likely time to replace it. Master Spa Parts has the perfect replacement part for you. The 1-Inch, MG Air Control w/ Blower Assist Tee is compatible with spas and hot tubs that accept a one-inch air control.

PREMIUM UNDERMOUNT HOT TUB COVER LIFTER
-Works with all cover shapes
-Undermount design- no screwing into spa
-Gas spring assisted

**Swim spa kit available for units up to 54" tall

This kit includes left and right brackets and screws for your CoverMate I Eco B. They are all factory direct, OEM replacement parts.

Temperature Sensor Mount. Used in older style Master Spas to secure the flow sensor to the spa. A new mount should always be installed when you are replacing your spa sensor unit.

This mount should fit with most sensors.

This left support arm for the CoverMate III is a powder coated replacement pivot arm of the original on your hot tub cover

*To determine if this is the correct replacement arm you need, look at your cover in the open position. While facing the spa and open cover lifter, the left arm is on the left side.*

The Master Spa® Factory OEM 78" x 78" (6.5') replacement hot tub cover (SKU: X457878) is specifically designed to fit your Master Spas® hot tub. This replacement custom hot tub cover ensures energy efficiency as it consists of a 1.5lb foam density, 6 inch thick foam insulation that tapers to 4 inch, full length heat seal cushions that help prevent heat loss, and upgraded black rubber handles.

.

The bracket is used for CoverMate easy to install the pole directly to your hot tub.

This ball stud for the CoverMate III SKU 100244 are the direct replacement parts for the original ball studs on your hot tub cover lift.
**These are sold individually**